Brother International CP60X Operation Manual - Page 9
Upper threading
View all Brother International CP60X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
14 Put the bobbin in, hold the end of the thread, push the bobbin down with your finger, and then pass the thread though the slit as shown. Counterclockwise Hold the bobbin. n For models equipped with the cutter ★ 1 Follow steps 1 to 2 of "Winding/Installing the bobbin". 2 Set the bobbin on the bobbin winder shaft, and then slide the shaft to the right. Notch Make sure the notch fits the projection. Projection * Follow this instruction so that the thread is correctly inserted through the tension spring of the bobbin case. For models equipped with the quick-set bobbin ★ Slit for the quick set bobbin Feed the end of the thread through the slit, and then pull the thread to cut it. Cutter * The thread feeding direction is indicated by arrows on the needle plate. XX You can begin sewing without drawing up the bobbin thread. When pulling up the bobbin thread before sewing, refer to "Drawing up the bobbin thread" (page 11). CAUTION • Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect. 15 Reattach the bobbin cover. * Make the end of the thread come out from the left side of the cover. Slit (cutter) * Check the installation orientation of the bobbin by using the "b" mark on one side of the bobbin as a reference. When placing the bobbin in the bobbin case, be sure to place it in the same orientation. 3 Wind five or six times. Pull the thread. The thread is cut at the slit. Slit CAUTION • Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out. 4 Turn on the machine. 5 Follow steps 7 to 15 of "Winding/Installing the bobbin". Upper threading CAUTION • Make sure you thread the machine properly. Otherwise, the thread could tangle and break the needle. • Never use a thread weight of 20 or lower. • Use the needle and the thread in the correct combination. (page 12) 1 Raise the presser foot lever. ★: Only for some models. 9