Brother International CP60X Operation Manual - Page 7
Threading the Machine
View all Brother International CP60X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2 Changing the initial needle position You can change the stitch selected when the machine is turned on to either "straight stitch (left needle position)" or "straight stitch (middle (center) needle position)". (Default: ) 1 Turn off the machine. 2 Holding down 2, turn on the machine. 3 After the machine has turned on, release 2. XX The initial needle position is changed. The currently selected stitch can be confirmed by the stitch number in the LCD. 3 Turning on/off the operation beep ★ You can turn on/off the operation beep. (Default: On) 1 Turn off the machine. 2 Holding down 3, turn on the machine. 3 After the machine has turned on, release 3. XX The operation beep setting is changed. 4 Changing the maximum sewing speed You can change the maximum sewing speed to either the standard or slower speed. (Default: Standard speed mode) When the slower speed mode is selected, the maximum speed adjusted with the sewing speed controller becomes slower. ★ 1 Turn off the machine. 2 Holding down 4, turn on the machine. 3 After the machine has turned on, release 4. XX The maximum sewing speed is changed. l : Slower speed mode : Standard speed mode 5 Turning on/off the automatic reverse/ reinforcement stitching You can set the machine to automatically sew reverse or reinforcement stitches at the beginning and end of stitching. (Default: Off) 1 Turn off the machine. 2 Holding down 5, turn on the machine. 3 After the machine has turned on, release 5. XX The automatic reverse/reinforcement stitching is turned on or off. l : On : Off * For details, refer to "Automatic reverse/reinforcement stitching" (page 17). ★: Only for some models. 6 Changing the needle mode You can change the needle mode to either the single or twin needle mode. (Default: Single needle mode) 1 Turn off the machine. 2 Holding down 6, turn on the machine. 3 After the machine has turned on, release 6. XX The needle mode is changed. : Single needle mode : Twin needle mode * For details, refer to "Sewing with the twin needle" (page 13). 7 Stitch adjustment ★ With some stitches, a stitch pattern may turn out poorly depending on the type of fabric. In such a case, you can make adjustments. (Default: 0) 1 Turn off the machine. 2 Holding down 7, turn on the machine. 3 After the machine has turned on, release 7. XX The machine turns into the stitch pattern adjustment mode. * For details, refer to "Making Adjustment" (page 23). Threading the Machine Winding/Installing the bobbin CAUTION • Make sure the power is off while threading the machine. If you accidentally step on the foot controller and the machine starts to sew, you could be injured. 11.5 mm (7/16 inch) • Be sure to use the included bobbins (part code: SA156, SFB: XA5539-151) or the same type. SA156 is Class 15 type bobbin. 1 Pull up the spool pin as far as possible, and put a spool of thread on this pin. Make sure that the thread unwinds as shown. CAUTION • If the spool of thread is not in the right place, the thread may tangle on the spool pin. 7