Brother International HL5050 Users Manual - English - Page 87
Service call indications, Table 1: LED indications after pressing Go and Job Cancel
UPC - 012502605645
View all Brother International HL5050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Service call indications If there is an error that cannot be put right, the printer will show that a service call is needed by lighting up all the LEDs as shown in Figure 3-12. Toner Drum Paper Status Figure 3-12 If you see the service call indication above, follow the steps below: 1 Take out the DIMM (Dual Inline Memory Module) from your printer, if you have a DIMM installed. 2 Turn off the power switch, wait a few seconds, and then turn it back on and try to print again. If you cannot clear the error and see the same service call indication after turning the printer back on, call your dealer or a Brother authorized service representative. When you press the Go and the Job Cancel buttons together, the LEDs will light up with one of the combinations shown in Table 1: LED indications after pressing Go and Job Cancel on page 3-6 to explain the error. For example, the LED indication below shows a fixing unit failure. Toner Drum Paper Status Figure 3-13 CONTROL PANEL 3 - 5