Brother International KE-436C Programmer Instruction Manual - English - Page 132
Repeat step 7 and create the program to point, when the needle point is at point D of
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
3. Input the stitch length and press . 3.0 mm is input in the example. Input 030 to make the stitch length to 3.0 mm. 4. Move the work clamp with . Press when the needle point is at point B of the pattern. 5. Move the work clamp with . Press when the needle point is at point C of the pattern. Point C becomes a sharp corner. The range from points A to C is programmed. 6. Press . To change the stitch length, specify the pitch value before pressing . 7. Move the work clamp with . Press when the needle point is at point D of the pattern. 8. Repeat step 7 and create the program to point E. 9. Press as in step 5. The range from points C to E is programmed. 10. Create the program to point I in the similar manner. Inputting the end code 1. Press . The work clamp returns to the start position. Saving 1. Specify the program number on the operation panel and press the read/write switch for writing into the floppy disk. Chapter 3 Programming with Command Function Programmer 131