Brother International KE-436C Programmer Instruction Manual - English - Page 189
Repeated copying, Copying data from the sewing start position or the feed point excluding
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Chapter 3 Programming with Command Function 5. Input the magnification in 3 digits in the Y direction and press . Magnification values of 0 - 400 are available for input. 6. Input the stitch length in 3 digits and press . If the value is "000", the stitch count remains unchanged. The stitch length increases or decreases. Repeated copying Command to be used Copying data from the sewing start position or the feed point (excluding the number of feed boundaries to be ignored) to the current needle position for the area after the current needle position 1. Move the needle to the desired position. Refer to "Moving needle point" (page 123). 2. Input . The needle follows the copied data. Press to cancel halfway. 188 Programmer
188
Programmer
Chapter 3 Programming with Command Function
5.
Input the magnification in 3 digits in the Y direction and press
.
Magnification values of 0 - 400 are available for input.
6.
Input the stitch length in 3 digits and press
.
If the value is "000", the stitch count remains unchanged. The stitch length increases or decreases.
Repeated copying
Command to be used
Copying data from the sewing start position or the feed point (excluding the
number of feed boundaries to be ignored) to the current needle position for
the area after the current needle position
1.
Move the needle to the desired position.
Refer to “Moving needle point” (page 123).
2.
Input
.
The needle follows the copied data. Press
to cancel halfway.