Brother International KE-436C Programmer Instruction Manual - English - Page 143

Chapter 3 Programming with Command Function 4. Move the work clamp with . Press when the needle point is at point 2 of the pattern. 5. Move the work clamp with . Press when the needle point is at point 3 of the pattern. Be sure to press for a split at a corner like point 3. If a split is not made, the corner will be round. 6. Program the following points up to point 17 with the curve programming steps. When there is a liner section, move the needle point from the split to the next split, and press . In the example, a linear line is programmed between points 7 and 9. Be sure to program a linear line also for the matched section between points 24 and 26. By pressing , the needle point is returned to the previous point. It cannot be returned beyond the previous split. By pressing , the needle point is returned to the previous split. However, when the needle point is at a split, it cannot be moved. By pressing , the needle point is returned to the split before the previous split. 7. Press . Move the work clamp with . Press when the needle point is at point 18 of the pattern. 8. Program the following points up to point 34 in the same manner. When programming, be sure that the points and splits specified on the inside line are paired with those on the outside line respectively. If there are any points or splits not paired, the needle automatically returns to the previous point. Correct the program. 9. Press and . Input the number of lines for a multiple stitch in . When the number should be "5", input "505". 10 Input the stitch length. Press . "3.0 mm" is input in the example. Input "030" to make the stitch length to 3.0 mm. 142 Programmer