Brother International MFC-790CW Software Users Manual - English - Page 158

PhotoCapture Center® For Network Users (For models with built-in network support) 7 a Put a USB Flash memory drive, CompactFlash® 1, Memory Stick™ 2, Memory Stick PRO™ 2, SecureDigital 3 or xD-Picture Card™ 4 into your machine. 1 This product also supports CompactFlash® type1. 2 MagicGate™ Memory Stick™ and Memory Stick PRO™ can be used, but any music data that is stored on the stick cannot be read. 3 This product supports SecureDigital High Capacity. 4 This product supports xD-Picture Card™ Type M / Type M+ / Type H (Large Capacity). b Start your browser software in which FTP is supported. Your browser software accesses the media using the FTP protocol and the network Host Name of the machine. You can also access the media by entering ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP address of your Brother machine) from your web browser. c Click the name of the file you want to see. 7 Note Using certain characters or symbols in a file name on the USB Flash memory or memory card may cause a problem accessing the file. We recommend to only use combinations of the following characters in a file name. 1234567890 ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz When you take out a media, do the following to prevent damage to the media. 7 a Close the browser. b Wait until the (Photo Capture) key stops blinking before taking out the media. CAUTION DO NOT unplug the power cord, USB cable or remove a USB Flash memory drive, CompactFlash®, Memory Stick™, Memory Stick PRO™, SecureDigital or xD-Picture Card™ from the machine while it is reading it (when the data. (Photo Capture) key is flashing). You could lose your data or damage the If you take out the media while the Photo Capture key is flashing, you must restart your PC at once before putting the same media back into the machine. If you do not restart your PC, the data on your media may be destroyed. 150