Canon 9540A003 OPTURA500 OPTURA400 Instruction Manual - Page 151
Troubleshooting
UPC - 013803040937
View all Canon 9540A003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Troubleshooting If you have a problem with your camcorder, refer to this checklist. Consult your dealer or a Canon Service Center if the problem persists. E Power Source Problem Cause Solution Camcorder will not turn Battery pack is exhausted. Replace or charge the 13 on. battery pack. Battery pack is not correctly Attach the battery pack 13 attached. correctly. The camcorder switches Battery pack is exhausted. Replace or charge the 13 off by itself. battery pack. Power save function has Turn on the camcorder. 24 been activated. Cassette compartment Battery pack is exhausted. Replace or charge the 13 will not open. battery pack. Cassette compartment cover Open the cassette 16 is not fully open. compartment cover fully. Cassette compartment Battery pack is exhausted. Replace or charge the 13 stopped during loading/ battery pack. unloading. The camcorder Consult a Canon Service - malfunctions. Center. LCD/viewfinder switches Battery pack is exhausted. Replace or charge the 13 on and off. battery pack. Battery pack will not charge. Battery packs will not Charge the battery pack in - charge outside the temperatures between 32 ºF temperature range of 32 ˚F and 104 ºF (0 ºC and 40 ºC). and 104 ˚F (0 ˚C and 40˚C). Battery packs become hot with use and may not charge. Wait until the battery pack - temperature is below 104 ˚F (40 ˚C) and retry charging. The battery pack is damaged. Use a different battery pack. - Recording/Playback Buttons will not work. "v" flashes on the screen. "k" flashes on the screen. "h" flashes on the screen. "REMOVE THE CASSETTE" appears on the screen. The wireless controller will not work. Camcorder is not turned on. Turn on the camcorder. Cassette is not loaded. Load a cassette. Cassette is not loaded. Load a cassette. Battery pack is exhausted. Condensation is detected. Replace or charge the battery pack. See reference page. Camcorder stopped operating to protect the tape. Camcorder and wireless controller are not set to the same remote sensor mode. Batteries of the wireless controller are exhausted. Unload and reload the cassette. Change the remote sensor modes. Replace the batteries. 23 16 16 13 147 16 78 19 151 Additional Information