Canon BJC5100 User Manual - Page 53

Insert the, banner paper, in the manual, feed slot., Cut the banner, at a crease, according to

Page 53 highlights

Cut the banner at a crease according to the length you need. r The maximum length you can use is six sheets (66 inches or 1676 mm). r Always leave an extra sheet at the end of the banner-just in case the type or graphics runs over at the end of the banner. Insert the banner paper in the manual feed slot. r Align the first sheet of the paper with the left edge of the manual feed slot and adjust the manual feed guide to the edge of the paper; then slide the sheet into the printer until it stops. r Do not allow the paper to hang over the edge of the desk or work table. Paper Handling Chapter 3 Paper Handling 3-21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110

Chapter 3
Paper Handling
3-21
Paper Handling
The maximum length you can use is six sheets (66 inches
or 1676 mm).
Always leave an extra sheet at the end of the banner—just
in case the type or graphics runs over at the end of the
banner.
Align the first sheet of the paper with the left edge of the
manual feed slot and adjust the manual feed guide to the
edge of the paper; then slide the sheet into the printer
until it stops.
Do not allow the paper to hang over the edge of the desk
or work table.
Insert the
banner paper
in the manual
feed slot.
Cut the banner
at a crease
according to the
length you need.