Canon FAXPHONE B95 FAXPHONE B95 User's Guide - Page 76
Using remote control, When your password is accepted
View all Canon FAXPHONE B95 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Using remote control 1 Call home. 2 The outgoing message will be played. 3 Press [#] while the outgoing message is playing. Enter your password when you hear the beeps indicating that you should enter your password. When your password is accepted, you will hear a confirmation tone (a short series of beeps). 4 The fax will now accept remote control commands (see List of remote control commands, p. 7-12). For example, press [1][1][#] to play back any telephone messages you may have received. When playback has finished, press [9][9][#] to end the remote control. 5 End the remote control and hang up the handset. • A password is required to use the remote control features. However, if PIN ENTRY is set to OFF (see p. 8-6), it is not necessary to enter your password when you use the FORWARDING MSG feature (see p. 7-13). 7 • If you enter an invalid password, you will hear an error tone. If you enter two invalid USING TAM MODE passwords consecutively, the call will be disconnected. • You should enter a remote command within 20 seconds of entering your password. If more than 20 seconds elapse after you enter your password and you do not enter a remote command, the call will be disconnected. • The remote control features can be used even when the fax is set to a mode other than TAM MODE. • In FAX ONLY MODE, the outgoing message will not be played. Press [#] when the call is connected. • In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If you have not set a Fax/Tel message, press [#] when the call is connected. • If MAN/AUTO SWITCH is off, the fax will ring 15 times. Press [#] while the outgoing message is playing. Then, enter your password when you hear the beeps. 7-11