Canon VB-M740E Network Video Recording Software RM Series Administrator Manual - Page 78
ettings Mode], ensitivity], Area Ratio], Duration], Active Region], Detection Indicator], Color
View all Canon VB-M740E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
(4) [Settings Mode] If you select [Simple], [Sensitivity] and [Area Ratio] can only be set using the sliders. [Duration] is fixed at 0.2 seconds. If you select [Advanced], the [Sensitivity], [Area Ratio] and [Duration] settings become available so that values can be set. (5) [Sensitivity] Specify the motion detection sensitivity within the range of 1 to 256. Increase the number to increase the sensitivity. (6) [Area Ratio] Specify the area of the preview video that the Storage Server uses for motion detection. The range is 0 to 100%. The size marker inside the Detection Indicator changes position depending on the value of this setting. (7) [Duration] Specify the length of time the motion signal must be present to decide that there is motion. The range is 0.0 to 5.0 seconds. (8) [Active Region] Displays a preview video from the camera used for motion detection. Displays a dotted-line frame representing the active region on top of the preview video. Drag the frame handles to make it larger or smaller. (9) [Detection Indicator] Size marker Notification Indicator Colored bar The size marker changes position depending on the value of the [Area Ratio] setting. Adjust the motion detection settings while viewing the preview video and the Detection Indicator. The colored bar changes depending on the value of the [Sensitivity] and the [Area Ratio] settings. Color of the Colored Bar Green Red Meaning The detected motion does not reach the values specified in [Sensitivity] and [Area Ratio]. In this case, the colored bar remains to the left of the size marker. The detected motion exceeds the values specified in [Sensitivity] and [Area Ratio]. In this case, the colored bar remains to the right of the size marker. The other settings are the same as those for continuous recording (p. 74). Important • If the recording period for a schedule ends while motion detection recording is in progress, recording will stop. • The detection indicator is not affected by the [Duration] setting. Be sure to take the detection time into account when adjusting the motion detection settings. • To perform motion detection on the Storage Server, you must specify [JPEG] for the [Video Format]. Also, if you simultaneously use more than one recording mode, all the [Video Format] settings must be [JPEG]. An error message is displayed if you try to use a format other than [JPEG] and motion detection on the Storage Server at the same time. • Make the [Priority] setting on the [Recording Settings] tab lower than the priority of any of the other recording settings. 78