Canon VIXIA HF R200 VIXIA HF R20 / HF R21 / HF R200 Instruction Manual - Page 49

Quick Start Function When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In standby mode the camcorder consumes only about 1/3 the power used when recording, saving energy when you are using a battery pack. Additionally, when you open the LCD panel, the camcorder is ready to start recording in approximately 1 second*, allowing you to record the subject right away. * The actual time required varies depending on the shooting conditions. Operating modes: 1 With the camcorder on and in a recording mode, close the LCD panel. A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the camcorder entered standby mode. 2 When you wish to resume recording, open the LCD panel. The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record. IMPORTANT • Do not disconnect the power source during standby mode (while the ON/OFF (CHG) indicator is lit in orange). NOTES • The camcorder will not enter standby mode if the LCD panel is closed while the ACCESS indicator is on or flashing, or while a menu is being displayed. The camcorder may also not enter standby mode if the LCD panel is closed when the battery charge is too low. Check that the ON/ OFF (CHG) indicator changes to orange. • About standby mode and auto power off: - The camcorder will power off automatically if left in standby mode for 10 minutes. Press x to turn on the camcorder. - You can select the length of time until shut-off or turn off the Quick Start function altogether with the 68 [Power Saving Mode] 8 [Quick Start (Standby)] setting. - The usual 5-minute auto power off setting of [Power Saving Mode] is not applicable while the camcorder is in standby mode. Smart AUTO Mode Š 49