Canon imageCLASS MF5950dw Wireless LAN Setting Guide - Page 6

Setting the wireless LAN Step4-A Setting the Machine Using the WPS (Push Button Mode) Follow this procedure only if you selected " Step4-A Setting the Machine Using the WPS (Push Button Mode)" on the previous page. 1. Make sure the procedure "Step2 Switching the Connection Method to Wireless LAN" (P.1-2) is completed. 2. Press [ ] (Menu). 6. Press [ ] or [ ] to select, and press [OK]. Wireless LAN Settings WPS Push Button Mode WPS PIN Code Mode SSID Settings Wireless LAN Informa... 3. Press [ ] or [ ] to select, and press [OK]. Menu Network Settings Preferences Timer Settings Common Settings 7. Press [ ] to select, and press [OK]. Do you want to connect with new settings? Yes No The next screen is displayed for approximately 5 seconds. You do not need to turn the machine OFF and ON at this stage. Changes effective after main power is turned OFF and ON. 4. Press [ ] or [ ] to select, and press [OK]. Network Settings Select Wired/Wirele... Wireless LAN Setting TCP/IP Settings SNMP Settings 5. Press [OK]. See Wireless LAN Setting Guide to perform settings. OK 8. Within 2 minutes, press and hold the WPS button on the wireless LAN router or access point. * The amount of time you must hold down the WPS button will depend on the model you are using. Please refer to the instruction manual for your wireless LAN routers and/or access points. Searching... Press the access point WPS button for about 5 seconds.  Cancel: Press Stop Connecting... Cancel: Press Stop If "Cannot find access point" is displayed. Press [OK] to close the screen and resume from Step 6. 1-4