Canon imagePROGRAF TM-200 MFP L24ei series User Manual - Page 146

LAN settings This setting item is displayed by tapping Device settings after tapping screen. (Setup) on the HOME Important • The administrator password is required to change settings if it is enabled for changing settings using the operation panel. Note • You can also enter LAN settings by tapping (Network) on the HOME screen. • Wi-Fi The following setting information on the Wi-Fi connection is displayed. (Some items are not displayed depending on printer settings.) Items Connection Network name (SSID) Communication mode Channel Wi-Fi security IPv4 address IPv4 subnet mask IPv4 default gateway IPv4 DNS dynamic setting IPv4 DNS host name IPv4 DNS domain name IPv6 link-local address IPv6 link-local prefix length IPv6 manual address IPv6 manual prefix length IPv6 stateless address 1 Setting Enabled (connected) / Enabled (disconnected) / Disable XXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXX (up to 32 characters) Infrastructure 1 - 13 Disable / WEP (64 bit) / WEP (128 bit) / WPA-PSK (TKIP) / WPA-PSK (AES) / WPA2-PSK (TKIP) / WPA2PSK (AES) XXX. XXX. XXX. XXX (12 characters) XXX. XXX. XXX. XXX (12 characters) XXX. XXX. XXX. XXX (12 characters) Enable / Disable XXXXXXXXXXXX XXXXXXXXXXXX XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX (32 characters) XXX (up to 3 digits) XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX (32 characters) XXX (up to 3 digits) XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX: XXXX (32 characters) 146