Canon imagePROGRAF iPF815 MFP M40 iPF815/iPF825 Setup Guide - Page 15
Load Paper to Adjust the Printhead
View all Canon imagePROGRAF iPF815 MFP M40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Load Paper to Adjust the Printhead Follow these steps to load a roll and adjust the Printhead alignment. The included Sample Paper is used in this example. 1 After the system has filled with ink when you are finished installing the Printhead and Ink Tanks, the message Select type of paper for printhead adj. is shown on the Display Screen. Press ▲ or ▼ to select Roll1 (Upper) (iPF815: Roll Paper) and press the OK button. 2 Open the Top Cover and lift the Ejection Guide. 3 Remove the Roll Holder from the printer. OK 4 Lift the Holder Stopper lever (a) from the shaft side to unlock the stopper. Holding the Holder Stopper at the position indicated (b), remove the stopper from the Roll Holder. 5 With the edge of the roll paper facing front as shown, insert the roll on the Roll Holder from the right. Insert the roll firmly until it touches the flange (a) of the Roll Holder. a a b • We recommend wearing clean cloth gloves when handling rolls to protect the printing surface. • Insert the roll firmly so that there is no gap between the roll and the flange of the Roll Holder. A gap may cause feeding problems. • Set the roll horizontally on a table or other flat surface to prevent the roll from falling. Dropping a roll may cause injury. • When loading a roll, be careful to avoid hitting the Roll Holder hard with the roll. This may damage the Roll Holder. 6 Insert the Holder Stopper in the Roll Holder from the left, as shown. Holding it at the position indicated (b), push it firmly in until the flange (a) of the Holder Stopper touches the roll. Lock the Holder Stopper lever (c) by pushing it down toward the shaft side. 7 Holding the Roll Holder so that the side with the white gear faces the side of the Roll Holder Slot with a white gear, load the Roll Holder shaft (a) into the grooves (b) on both ends of the Roll Holder Slot. b ac ab ab • Insert the roll firmly to eliminate any gap between the roll and the flange of the Roll Holder. A gap may cause feeding problems. • If the paper is wrinkled or warped, straighten it out before loading it. • Be careful not to cause injury by dropping a roll. Caution • Be careful not to put the fingers between the guide grooves (b) and the Roll Holder shaft (a) when loading a roll. Otherwise, you may hurt yourself. 8 Pull out the roll paper evenly on both ends, insert the roll paper in the Paper Feed Slot (a), and advance the roll paper until you hear a tone. 9 Lower the Ejection Guide. a 15