Canon imagePROGRAF iPF815 MFP M40 iPF815/iPF825 Setup Guide - Page 3
Assemble the Stand, Install the Roll Unit, Install the Printer
View all Canon imagePROGRAF iPF815 MFP M40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Assemble the Stand Assemble the stand, in preparation for printer installation. For stand assembly instructions, refer to the Printer Stand Setup Guide provided with the stand. Install the Roll Unit Install the roll unit on the stand. (iPF825 only.) For roll unit installation instructions, refer to the Printer Stand Setup Guide provided with the stand. Install the Printer 1 Remove the packaging material on top of the printer. Mount the printer on the stand. 2 While two people hold the carrying handles under the printer on one end and lift the printer a little, have a third person remove the packaging material and the plastic covering from under the printer. After the packaging material has been removed, lower the printer. 3 Remove the packaging material and the plastic covering from the other side of the printer the same way. Instructions for iPF825 4 Pull out the roll unit. 5 With three people holding the carrying handles under the printer on both ends, lift the printer. • The printer alone weighs approximately • When moving the printer, firmly grasp the 112 kg. Moving the printer requires at least carrying handles (a) under each side. Holding Caution six people, three on either side. Be careful the printer at other positions is dangerous to avoid back strain and other injuries. and cause injury and damage if the printer is dropped. a 6 Align the triangles on the back of the printer and Stand when setting the printer on the Stand. Secure the printer and Stand firmly together using four M4 hex screws on each side by the Allen Wrench. Instructions for iPF825 7 Push in the roll unit. 3