Canon imagePROGRAF iPF815 MFP M40 iPF815/iPF825 Setup Guide - Page 16

10 Close the Top Cover. 11 Press the OK button. The paper is now advanced. OK After loading a roll, the printer automatically shows a menu for selection of the paper type on the Display Screen and beeps. 12 On the Roll 1 (Upper) Type screen (on the iPF815, the Roll Media Type screen), press ▲ or ▼ to select the type of paper loaded, and then press the OK button. To identify the type of paper, refer to the label on the box of sample paper. Select HW Coated for heavyweight coated paper or Coated Paper for regular coated paper. • If the message The paper is loaded crooked. Lift the release MEMO lever. is displayed, lift the Release Lever, open the Top Cover, and align the right edge of the roll parallel to the Paper Alignment Line. Printhead alignment starts automatically. This process takes about six minutes. When the process is complete, Online is displayed. You are now finished loading the roll. Store Accessories in the Pockets 1 Store the 3-Inch Paper Core Attachment and other accessories in the accessory pocket. 2 Use the manual pocket to store the Basic Guide (which includes descriptions of basic printer operations, routine maintenance, and troubleshooting tips), so you can refer to it as needed. Responding to Messages Error messages may appear on the Display Screen of the Control Panel during printer installation in some cases. If so, it may not indicate a problem with the printer, and the issue may be easily resolved. Common messages and the causes are listed here with corrective actions. To respond to error messages other than these, refer to the provided Basic Guide (2). For other detailed printer instructions, refer to the User's Guide on the User Manuals CD-ROM. Message The paper is loaded crooked. Lift the release lever. No ink tank loaded. Insert the maintenance cartridge. Turn off printer, wait, then turn on again. Paper cutting failed. Lift the release lever. No printhead Hardware error. xxxxxxxx-xxxx Cause Paper has been loaded askew. There is no Ink Tank of the indicated color in the printer. The Maintenance Cartridge is not installed. Fastening tape or the Belt Stopper has not been removed inside the Top Cover. For some reason, the paper could not be cut. The Printhead is not installed. Another kind of error has occurred. ERROR Exxx-xxxx (x represents a letter or number.) An error requiring service may have occurred. Corrective Action 1. Lift the Release Lever and open the Top Cover. 2. Align the right edge of the roll paper parallel to the right Paper Alignment Line. 3. Lower the Release Lever and close the Top Cover. Load or reload the Ink Tank. (See steps 1-8 on page 6-7.) Install the Maintenance Cartridge. 1. Turn the printer off. 2. Open the Top Cover and remove the tape or Belt Stopper. (See step 3 on page 4.) 3. Turn the printer on. Refer to the provided Basic Guide (2). Reinstall the Printhead. (See steps 1-10 on page 5-6.) Turn off the printer and wait at least three seconds before restoring the power. If the message is still displayed after this, write down the error code and message, turn off the printer, and contact your Canon dealer for assistance. Write down the error code and message, turn off the printer, and contact your Canon dealer for assistance. 16