Cisco 7935 Administration Guide - Page 32

Preparing to Install Chapter 2 Installation of the Cisco IP Conference Station 7935 If you enable auto-registration in Cisco CallManager, after you connect the IP Conference Station to the network, the station begins the automatic startup process to obtain a directory number. You can also use auto-registration to quickly register all stations with the Cisco CallManager database. You can then modify any settings, such as the directory numbers, from Cisco CallManager. The following procedure provides an overview of the steps you must perform in Cisco CallManager. Refer to the Cisco CallManager Administration documentation or online help in the Cisco CallManager Administration application for additional information. Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Start Cisco CallManager Administration. Enable auto-registration in Cisco CallManager by selecting System > Cisco CallManager. From the list of Cisco CallManagers, select the Cisco CallManager where you want to check auto-registration. Verify that the "Auto-registration Disabled on this Cisco CallManager" setting is not selected. Install the station by following the instructions in the "Installing the Cisco IP Conference Station 7935" section on page 2-6. To modify settings, return to Cisco CallManager Adminisration and select Device > Phone. Enter search criteria for the new IP Conference Station and click Find. You should see the MAC address for the new IP Conference Station. Adding IP Conference Stations Manually If you want to assign specific directory numbers to specific IP Conference Stations without using auto-registration, you must manually add each station to the Cisco CallManager database. If you are not using Dynamic Host Configuration Protocol (DHCP) in your network, you must also configure the IP settings and Trivial File Transfer Protocol (TFTP) server locally on each station. Cisco IP Conference Station 7935 Administration Guide 2-4 78-12727-03