Cisco C3230-1W-49-K9 Hardware Guide - Page 38
Cisco 3270 Rugged Router Card Component Systems
View all Cisco C3230-1W-49-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Chapter 2 Cisco 3270 Rugged Router Card Note The Cisco 3270 router can be ordered with one Gigabit Ethernet copper interface and one fiber optic interface, or with two Gigabit Ethernet copper interfaces. The port configurations are not interchangeable. The PCI bus connector supports communication between the Serial Mobile Interface Card (SMIC), the Fast Ethernet Switch Mobile Interface Card (FESMIC), and the Cisco 3270 Rugged Router card. The Wireless Mobile Interface Card (WMIC) communicates with the router through an internal Fast Ethernet port. The WMIC is configured through an independent console port; the card draws power only from the bus. Note For detailed information about the Cisco 3270 Rugged Router card, such as header pin assignments, see the "Cisco 3200 Series Mobile Access Router Technical Reference" (OL-1927). Cisco 3270 Rugged Router Card Component Systems The industry-standard architecture (ISA) buses and peripheral component interconnect (PCI) buses on the Cisco 3200 Series Mobile Access Router cards provide power to the components on the cards. Both buses comply with the PC/104-Plus standard. The ISA bus allows PC/104-Plus ISA signals to pass through the card bus, but the Cisco cards do not use any of the signals. The PCI bus signals allow the Cisco SMIC and FESMIC to communicate with the Cisco 3270 Rugged Router card. The WMIC draws power from the bus, but it does not communicate with the router through the buses. It communicates with the router through an internal Fast Ethernet port. Non-Cisco cards cannot communicate with the router over the PCI bus. Caution If you add non-Cisco cards that generate signals on the PCI bus, the router might shut down. Please do not add non-Cisco cards that generate signals on the PCI bus. Cisco 3200 Series Router Hardware Reference 2-2 OL-5816-10