Clifford Arrow 5 Owners Guide - Page 11

disarming without a transmitter, remote siren silencing, transmitter chirp muting - installation guide

Page 11 highlights

disarming without a transmitter This feature allows you to disarm the system without the transmitter should it be lost, damaged, or disabled. In order to disarm without a transmitter, you must have the vehicle's ignition key, know where the PlainView 2 Valet switch is located, and have the PIN code. Be sure to check with the installer for the location of the PlainView 2 Valet switch and instructions for entering the PIN code. Turn the ignition On and then press the button twice (factory PIN default setting) and the button once to disarm without a transmitter. remote siren silencing This system offers remote siren silencing. Remote siren silencing is a fea- ture that makes it possible to silence and reset the system when it is triggering without disarming the system. If the system is triggered and the siren has been sounding, press on the transmitter to stop the trigger and return the unit to the armed state. The system will not dis- arm, but rather reset. This prevents you from disabling the system should you wish to silence it without visually checking the vehicle. After resetting the system, press again to disarm the system. transmitter chirp muting To temporarily turn off the arm or disarm chirps, use transmitter chirp muting. Simply press and simultaneously on the trans- mitter, and the confirmation chirp(s) will be eliminated for that one op- eration only. The parking lights will flash to confirm the arm/disarm command. If you want the arm/disarm chirps turned off permanently, please refer to the User-Selectable Features section of this guide. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37

8
disarming without a transmitter
This feature allows you to disarm the system without the transmitter
should it be lost, damaged, or disabled. In order to disarm without a
transmitter, you must have the vehicle’s ignition key, know where the
PlainView 2 Valet switch is located, and have the PIN code. Be sure to
check with the installer for the location of the PlainView 2 Valet switch
and instructions for entering the PIN code. Turn the ignition On and
then press the
button twice (factory PIN default setting) and the
button once to disarm without a transmitter.
remote siren silencing
This system offers remote siren silencing. Remote siren silencing is a fea-
ture that makes it possible to silence and reset the system when it is
triggering without disarming the system. If the system is triggered and
the siren has been sounding, press
on the transmitter to stop the
trigger and return the unit to the armed state. The system will not dis-
arm, but rather reset. This prevents you from disabling the system
should you wish to silence it without visually checking the vehicle. After
resetting the system, press
again to disarm the system.
transmitter chirp muting
To temporarily turn off the arm or disarm chirps, use transmitter chirp
muting. Simply press
and
simultaneously on the trans-
mitter, and the confirmation chirp(s) will be eliminated for that one op-
eration only. The parking lights will flash to confirm the arm/disarm
command. If you want the arm/disarm chirps turned off permanently,
please refer to the
User-Selectable Features
section of this guide.