Cobra XRS 9670 XRS 9670 Manual - Page 10
What to Remember While Using IntelliMute, Setting the IntelliMute Activation Point, CAUTION
View all Cobra XRS 9670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Your Detector Settings What to Remember While Using IntelliMute IntelliMute works with all City and Auto Mute modes. Whenever engine revs are below the activation point, an arrow pointing down will appear in the display. Above the activation point, an arrow pointing up will appear. Below Activation Point Above Activation Point N W i h NW i h If, for any reason, the unit stops sensing your engine's revs, IntelliMute will indicate an error and automatically turn Off. The rev point you set will be stored in the unit's memory when power is turned Off and recalled each time the power is turned On. NOTE The rev point must be reset if you use your detector in a different vehicle. NOTE When initially choosing your IntelliMute activation point, a setting of approximately 300 to 600 RPMs above idle is recommended. You can reset the activation point at any time to fit your individual preferences and driving style. Setting the IntelliMute Activation Point Your detector must be installed in your vehicle. CAUTION Do not attempt to set the rev point while driving. Your vehicle should be parked and idling. IntelliMute must be turned On before setting the activation point. 14 English Your Detector Settings Program/Mute Button Set/City Button Select/Dim Button To Set the IntelliMute Activation Point Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Set IntelliMute. Tone None Visual Display Set IntelliMute Press and release the Set/City button Two beeps to begin setting IntelliMute RPMs. Rev your engine to the level you wish to None set. Rev the engine slightly above idle and hold revs steady for two seconds. Press SET at desired RPMs... None At the desired rev level, press and release the Set/City button. Three beeps Press and release either the Select/ None Dim button to proceed to the next user mode or the Program/Mute button to exit the Program mode. IntelliMute Set! None Setting IntelliMute RPMs Set Intel... Press SET... Intelli NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. Tone One beep One beep Visual Display IntelliMute not set Please try again IntelliMute Off IntelliMute Not Set IntelliMu... Please tr... Mute Set! IntelliMute Off Intelli Mute Off Nothing Comes Close to a Cobra® 15