Cobra XRS 9670 XRS 9670 Manual - Page 12

Settings Program/Mute Button Set/City Button Select/Dim Button To Calibrate the Compass Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Set Compass. Tone None Press and release the Set/City button One beep to begin setting the compass. Within two minutes, drive your vehicle in a circle twice, then press the Set/City button again. Three beeps Press and release either the Select/ None Dim button to proceed to the next user mode or the Program/Mute button to exit Program mode. Set Compass Calibrate Compass Compass Set Set Compa... Drive in... Compass Visual Display Set Compass Drive in 2 circles... Press SET when done... Compass Set! For two seconds followed by direction of travel (N, NE, E, SE, S, SW, W or NW) None NW h Press SET... Set! NOTE If you do not press the Set/City button within two minutes after beginning the set compass process, compass calibration will automatically terminate. Tone One beep Visual Display Compass not set... Please try again... Terminate Compass n... Please tr... 18 Your Detector Settings Pop Alert The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses a single, short-time pulse to measure the target vehicle's speed. The Pop mode receiver senses Pop singles beyond the effective range of Pop radar guns. As the Pop mode receiver is so sensitive, you should limit the use of Pop Detect mode to highway and rural driving. Pop Alert will alert you to Pop radar signals. During the alert, the unit continues to detect other signals. The factory setting is Pop Detect Off. To Turn Pop Detect Mode On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Pop Detect. Tone Two beeps Visual Display Pop On One beep Pop Off Pop Detect On Pop On Pop Detect Off Pop Off K, Ku and X Band Detection The new Ku Band may be introduced to North America in the future. To prevent false alerts until it is, the factory default for Ku Band detection is Off. In parts of North America, annoying false alerts from door openers and similar devices are triggered on the X Band and K Band. If desired, X Band or K Band can be turned Off. The factory default for X Band and K Band detection is On. To Turn X, K and/or Ku Mode On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to X, K or Ku band. Tone Two beeps Visual Display X-Band On One beep X-Band Off X-Band On Two beeps One beep K-Band On K-Band Off X-Band Off Two beeps Ku-Band On X-Band Off One beep Ku-Band Off K-Band On K-Band On K-Band Off K-Band Off Ku-Band On Ku-Band On Ku-Band Off Ku-Band Off Comes Close to a Cobra® 19