Cobra XRS 9670 XRS 9670 Manual - Page 9

Your Detector Settings Muting an Alert Your detector allows you to quickly turn Off an Audio Alert by momentarily pressing the Program/Mute button. If you press the Program/Mute button a second time during the Alert, the Audio Alert will be turned back On. Program/Mute Button Press and release To Turn On or Off an Audio Alert Using the Program/Mute Button Press and release the Program/Mute button. Tone None Visual Display None Auto Mute Mode Auto Mute will automatically reduce the audio volume of all alerts after four (4) seconds for as long as the signal is detected. The factory setting for Auto Mute is On. To Turn Auto Mute On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Auto Mute. Tone Two beeps Visual Display Auto Mute On One beep Auto Mute Off Auto Mute On Auto Mute Off AutoMute AutoMute On Off Auxiliary Audio Jack The Auxiliary Audio Jack can be used to connect an external speaker in environments with high ambient noise levels. The internal speaker will be disconnected. 12 English Auxiliary Audio Jack Your Detector Settings IntelliMute IntelliMute is a unique feature that allows you to avoid alerts you don't need to hear because you are stopped or moving slowly. By sensing the "revs" RPMs) of your engine, IntelliMute knows when you are at low speed and automatically mutes audio alerts (except for strobe signals from emergency vehicles). Before IntelliMute will work, you must set an activation point for your engine's revs (see page 14). Whenever the revs are below that point, IntelliMute will begin muting. The activation point will be stored in memory and recalled each time the power is turned On. An i will appear in the display when IntelliMute is On. The factory setting is IntelliMute Off. NOTE IntelliMute may not work with some vehicles because it cannot sense the engine's revs. In such cases, you can reduce unwanted audio alerts by using Auto Mute and City mode when appropriate. To Turn IntelliMute On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to IntelliMute. Tone Two beeps Visual Display IntelliMute On, then i appears in the display One beep IntelliMute Off IntelliMute On IntelliMute Off Intelli Intelli Mute Mute On Off N W i h Nothing Comes Close to a Cobra® 13