Cobra XRS 9670 XRS 9670 Manual - Page 5
Getting Started, Installation - detector
View all Cobra XRS 9670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Your Detector Installation Dashboard Mounting 1. Place the detector on the dashboard to find a location where the unit has a clear, level view of the road. The angle can NOT be adjusted after mounting. 2. Remove the paper backing from one side of the hookand-loop fastener. 3. Attach the pad to the dashboard at your chosen location and remove the other paper backing. 4. Attach the detector to the hook-and-loop fastener. You can remove and reattach the unit as often as you like. 5. Plug the power cord into the detector. 6. Plug the cigarette lighter adapter on the power cord into your vehicle's cigarette lighter. 4 English Your Detector Getting Started Getting Started • On-Off/ Volume Control Rotate clockwise (away from you) To Turn On the Unit and Adjust the Audio Volume Rotate the On-Off/ Volume control clockwise (away from you). Tone Three beeps Visual Display Testing System Ready The display will then cycle through the user mode settings (city or highway, Intellimute and SmartPower status). Start-up is complete when the display shows - - h. Important: Once the compass is calibrated, the dashes will change to one of the cardinal compass directions (N, NE, E, SE, S, SW, W, NW). See page 17 to calibrate the compass. Power On Testing Start-Up Complete __ h System Ready NOTE In some vehicles, power is supplied to the cigarette lighter even while the ignition is Off. If this is the case with your vehicle and you have turned the SmartPower Off, you should turn Off or unplug your detector when parking for lengthy periods. Cobra recommends leaving SmartPower at the factory setting, which is On. Nothing Comes Close to a Cobra® 5