Compaq 400 320 321 420 421 620 and 621 Notebook PC and 420 and 620 Notebook PC - Page 99
Remove the Torx M2.5×6.0 screw
View all Compaq 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
3. Remove the Torx M2.5×6.0 screw (3) then, lift the USB connector assembly (4) from the base enclosure. Remove the USB connector assembly on 35.6-cm (14.0-in) and 33.8-cm (13.3-in) computers: 1. Position the computer right-side up with the right side toward you. 2. Release the ZIF connector (1) and remove the cable (2) from the system board. 3. Lift the USB connector assembly (3) that is held on the base enclosure with adhesive. Reverse this procedure to install the USB connector assembly. Component replacement procedures 91
3.
Remove the Torx M2.5×6.0 screw
(3)
then, lift the USB connector assembly
(4)
from the base
enclosure.
Remove the USB connector assembly on
35.6-cm
(14.0-in) and
33.8-cm
(13.3-in) computers:
1.
Position the computer right-side up with the right side toward you.
2.
Release the ZIF connector
(1)
and remove the cable
(2)
from the system board.
3.
Lift the USB connector assembly
(3)
that is held on the base enclosure with adhesive.
Reverse this procedure to install the USB connector assembly.
Component replacement procedures
91