Compaq ProLiant 7000 SMART-2DH Array Controller Reference Guide - Page 182

H-7 continued POST Error Messages continued 1785 Slot 1 Drive Array not Configured (followed by one of the following:) (1) Run Compaq Array Configuration Utility. (2) No drives detected. (3) Array Accelerator Memory Size Increased. (4) External Cable(s) Attached to Wrong SCSI Port Connector(s). (5) Drive positions cannot be changed during Capacity Expansion. (6) Drive positions appear to have changed. (7) Configuration information indicates drive positions beyond the capability of this controller. This may be due to drive movement from a controller that supports more drives than the current controller. (8) Configuration information indicates drives were configured on a controller with a newer firmware version. (1) Run the Compaq Array Configuration Utility. (2) Turn off system and check SCSI cable connections to make sure drives are attached properly. (3) Run the Compaq System Configuration Utility. (4) Turn system power OFF and swap SCSI port connectors to prevent data loss. (5-6) Run Drive Array Advanced Diagnostics if previous positions are unknown. Then turn system power OFF and move drives to their original positions. (7) To avoid data loss turn system power OFF and reattach drives to the original controller. (8) To avoid data loss, reattach drives to original controller or upgrade controller firmware to the version on the original controller using Option ROMPaq. Select F1 key to resume. 1786 Slot x Drive Array Recovery Needed. The following SCSI drive(s) need Automatic Data Recovery: SCSI Port (y): SCSI ID (x) Select F1 to continue with recovery of data to drive. Select F2 to continue without recovery of data to drive. Or Slot x Drive Array Recovery Needed. The following SCSI drive(s) need Automatic Data Recovery: SCSI Port (y): SCSI ID (x) Select F1 to retry Automatic Data Recovery Select F2 to continue without starting Automatic Data Recovery. The message normally appears when a drive was replaced in a fault-tolerant configuration with system power off. In this case, press F1 to start the automatic data recovery process. The "previously aborted" version of the 1786 POST message will appear if the previous rebuild attempt was aborted for any reason. Run Drive Array Advanced Diagnostics (DAAD) for more information. If the replacement drive was failed, try using another replacement drive. If rebuild was aborted due to a read error from another physical drive in the array, you'll need to back up all readable data on the array, run Diagnostics Surface Analysis, and then restore your data. 1787 Slot x Drive Array Operating in Interim Following a system restart, this message Recovery Mode. The following SCSI drive(s) reminds you that drive x is defective and fault SMART-2DH Array Controller Reference Guide Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002 File Name: O-APPH.DOC Last Saved On: 2/27/98 12:10 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED