Craftsman 536.270320 Owners Manual - Page 10
How To Install The Seat, Check The Level Of The Mower, Housing
View all Craftsman 536.270320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ASSEMBLY HOW TO INSTALL THE SEAT i: Use the fasteners shown belowto install the seat. The fasteners are shown at full size: :_ .... : Seat Hinge '_lx45 :i{B) :::: ;: i::18x16 Seat Bracket 2x53 ..... .... (D) 15x88 1 Set the seat bracket on the seat support (Figure 5) Pull the wire harness between the seat hinge and the seat bracket. 2 Fasten the seat bracket to the seat support with the fasten- .... ers. Do nottighten the fasteners ..... 3. Carefully remove the protective sleeve and the plastic bag from the seat, Do not damage the wire attached to the bottom of the seat. Atign the holes in the seat hinge to the holes in the seat (Figure 6). Fasten the seat to the seat hinge with the fasteners as shown. Tighten the fasteners. Check the operatingposition of the seat. :If:the seat needs to be adjusted, slide the seat bracket forward or backward along the seat adjusting holes as shown To keep the seat straight, tighten the rear nut and then tighten the two front nuts Fasten the connector to the wire harness. Make sure the tab on the connector locks into the wire harness. WfaAstReNn INtGhe: Fcoorncnoercrteocrt atnod tshaefe woipreerahtiaornneosfst.heIfunthite, connector is not attached, the engine will stop when the attachment clutch is engaged. ii i ,i D Figure 5 Seat Adjustin_°_les "_ gure 6 CHECK THE LEVEL OF THE MOWER HOUSING NOTE: After the unit is fully assembled, read the Operation section. The level of cut was set at the factory To check the level of cut, mow a short distance and look at the area that was cut If the mower housing does not cut level, see the instructionson "How To Level The Mower Housing" in the Service And Adjustment section of this instruction book. F-99636 t0 Downloaded from www.Manualslib.com manuals search engine