Craftsman 536.270320 Owners Manual - Page 26
Service, And Adjustment
View all Craftsman 536.270320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
SERVICE AND ADJUSTMENT HOW TO ADJUST THE THROTrLE CONTROL For the best engine performance, set the throttle control as follows 1 Move the throttle control to the FAST position (Figure 29). 2. Loosen the clamp screw so that the throttle control cable can move in the cable clamp (Figure 30) Do not remove the cable clamp or disconnect the throttle control cable from the engine control lever. 3. Move the engine control lever until the stot in the lever is aligned (lines up) with the hole in the control bracket as shown. 4. Tighten the clamp screw. Move the throttle control to the SLOW positionand then back to the FAST position.Check the atignment of the throttle control lever See step 3. The throttle control is now set at the correct speed When the throttle control is at the FAST position, the engine speed is 3400 + or - 100 RPM. When the throttle control is in the SLOW position, the engine speed is 2150 + or- 100 RPM. IMPORTANT; Do not change the engine governor. If the engine governor needs an adjustment, go to the nearest Authorized Service Center. They have the equipment and experience to make the adjustment. CHOKE / FAST Throttle Control SLOW Figure 29 Engine Control Lever - FAST position (Skitin leveralignedwithholein bracket) Throttte Control Cable Cable Clamp Clamp Screw Control Bracket Figure 30 F-99636 26 Downloaded from www.Manualslib.com manuals search engine