D-Link DGS-3427 Product Manual - Page 330

xStack® DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch To define an Enable Login Method List, set the following parameters: Parameter Description Method List Name Method 1, 2, 3, 4 Enter a method list name defined by the user of up to 15 characters. The user may add one, or a combination of up to four of the following authentication methods to this method list: local_enable - Adding this parameter will require the user to be authenticated using the local enable password database on the Switch. The local enable password must be set by the user in the next section entitled Local Enable Password. none - Adding this parameter will require no authentication to access the Switch. radius - Adding this parameter will require the user to be authenticated using the RADIUS protocol from a remote RADIUS server. tacacs - Adding this parameter will require the user to be authenticated using the TACACS protocol from a remote TACACS server. xtacacs - Adding this parameter will require the user to be authenticated using the XTACACS protocol from a remote XTACACS server. tacacs+ - Adding this parameter will require the user to be authenticated using the TACACS protocol from a remote TACACS server. server_group - Adding a previously configured server group will require the user to be authenticated using a user-defined server group previously configured on the Switch. Click Apply to implement the changes. To return to the Enable Method Lists window, click the Show All Authentication Enable List Entries link. Configure Local Enable Password This window will configure the locally enabled password for the Enable Admin command. When a user chooses the "local_enable" method to promote user level privileges to administrator privileges, he or she will be prompted to enter the password configured here that is locally set on the Switch. To view this window, click Security > Access Authentication Control > Configure Local Enable Password, as shown below. Figure 6 - 55 Configure Local Enable Password window To set the Local Enable Password, set the following parameters and click Apply. Parameter Description Old Local Enable New Local Enable Confirm Local Enable If a password was previously configured for this entry, enter it here in order to change it to a new password Enter the new password that you wish to set on the Switch to authenticate users attempting to access Administrator Level privileges on the Switch. The user may set a password of up to 15 characters. Confirm the new password entered above. Entering a different password here from the one set in the New Local Enabled field will result in a fail message. Click Apply to implement changes made. 321