D-Link DWS-1008 Product Manual - Page 111

The access level specifies the read-write privileges of the community string: read-only - An SNMP management application using the string can get (read) object values on the switch but cannot set (write) them. This is the default. read-notify - An SNMP management application using the string can get object values on the switch but cannot set them. The switch can use the string to send notifications. notify-only - The switch can use the string to send notifications. read-write - An SNMP management application using the string can get and set object values on the switch. notify-read-write - An SNMP management application using the string can get and set object values on the switch. The switch can use the string to send notifications. To clear an SNMP community string, use the following command: clear snmp community name comm-string The following command configures community string switchmgr1 with access level notify-read-write: DWS-1008# set snmp community name switchmgr1 notify-read-write success: change accepted. Creating a USM User for SNMPv3 To create a USM user for SNMPv3, use the following command: set snmp usm usm-username snmp-engine-id {ip ip-addr | local | hex hex-string} access {read-only | read-notify | notify-only | read-write | notify-read-write} auth-type {none | md5 | sha} {auth-pass-phrase string | auth-key hex-string} encrypt-type {none | des | 3des | aes} {encrypt-pass-phrase string | encrypt-key hex-string} To clear a USM user, use the following command: clear snmp usm usm-username snmp-engine-id {ip (ip-addr) | local | hex (hex-string)} The usm-username can be up to 32 alphanumeric characters long, with no spaces. You can configure up to 20 SNMPv3 users. D-Link DWS-1008 User Manual 92