D-Link DWS-1008 Product Manual - Page 87

DWS-1008# show ip route Router table for IPv4 Destination/Mask Proto Metric 0.0.0.0/ 0 Static 1 0.0.0.0/ 0 Static 2 10.0.2.1/24 IP 0 10.0.2.1/32 IP 0 10.0.2.255/32 IP 0 224.0.0.0/ 4 IP 0 NH-Type Router Router Direct Direct Direct Local Gateway 10.0.1.17 10.0.2.17 Adding a Static Route To add a static route, use the following command: set ip route {default | ip-addr mask | ip-addr/mask-length} default-router metric The metric (cost) can be any number between 0 and 2,147,483,647. Lower-cost routes are preferred over higher-cost routes. When you add multiple routes to the same destination, MSS groups the routes together and orders them from lowest cost at the top of the group to highest cost at the bottom of the group. If you add a new route that has the same destination and cost as a route already in the table, MSS places the new route at the top of the group of routes with the same cost. To add a default route that uses default router 10.5.4.1 and has a cost of 1, type the following command: DWS-1008# set ip route default 10.5.4.1 1 success: change accepted. To add two default routes and configure MSS to always use the route through 10.2.4.69 when the switch interface to that default router is up, type the following commands: DWS-1008# set ip route default 10.2.4.69 1 success: change accepted. DWS-1008# set ip route default 10.2.4.17 2 success: change accepted. To add an explicit route from a switch to any host on the 192.168.4.x subnet through the local router 10.5.4.2, and give the route a cost of 1, type the following command: DWS-1008# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1 success: change accepted. D-Link DWS-1008 User Manual 68