D-Link DWS-1008 Product Manual - Page 149

Changing AP Names The default name of a directly attached AP is based on the port number of the access port attached to the AP. For example, the default name for an AP on access port 1 is AP01. The default name of a Distributed AP is based on the number you assign to it when you configure the connection. For example, the default name for Distributed AP 1 is DAP01. AP names appear in the output of some CLI show commands. To change the name of an AP, use the following command: set {ap port-list | dap dap-num} name name Changing Bias The CLI commands described in this section enable you to change the bias for an AP. To change the bias of an AP, use the following command: set {ap port-list | dap dap-num} bias {high | low} The default bias is high. To change the bias for a Distributed AP to low, type the following command: DWS-1008# set dap 1 bias low success: change accepted. Configuring a Load-Balancing Group A load-balancing group is a named set of access points. MSS balances user sessions among the access points in the group. To assign an access point to a load-balancing group, use the following command: set {ap port-list | dap dap-num} group name To configure a load-balancing group named loadbalance1 that contains directly-connected access points on ports 1, 4, and 6, type the following command: DWS-1008# set ap 1,4,6 group loadbalance1 success: change accepted. D-Link DWS-1008 User Manual 130