Dacor EO230 Installation Instructions - Page 16

Verify Proper Operation

Page 16 highlights

Installation Instructions Install Exhaust Deflector caution Install the exhaust deflector before installing the oven door(s). Attach the exhaust deflector to the front of the oven. It attaches to the oven just below the oven chamber in the door jam. On a double oven, the exhaust deflector is mounted below the bottom oven chamber. 1. Line up the mounting holes on the exhaust deflector with the screw holes on the front of the oven. 2. Secure it using the three (3) screws provided. 1. Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. See facing page. 2. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. 3. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle. 4. Lower the door to the fully opened position. 5. Rotate the two hinge locks toward the oven. Slowly and carefully open and close the door completely to make sure that it is properly installed. Verify Proper Operation Reinstall the Oven Door(s) warning To avoid damage to the door or personal injury from it falling off its hinges: • Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door. • Rotate the hinge locks toward the front of the oven immediately and completely after installation of the door. warning Read the accompanying use and care manual completely before using the oven. 1. Remove any packaging from inside the oven(s). 2. On some models there is protective plastic coating over the stainless steel surfaces. Peel them off before use. 3. Slide the oven racks onto the support racks in the oven chamber(s) as instructed in the use and care manual. 4. Turn on the power to the oven at the circuit breaker or fuse box. Set the clock as instructed in the use and care manual. 5. Set the oven to bake mode as instructed in the use and care manual. NOTES: If the oven does not operate properly, follow these troubleshooting steps: • Verify that power is supplied to the oven. • Check for proper electrical connection. • Repeat the above bake test. • If the appliance still does not work, contact Dacor • Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call. See page 3 for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. caution On double ovens: Install the upper door first to prevent damage to the lower door. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

14
Installation Instructions
Install Exhaust Deflector
CAUTION
Install the exhaust deflector before installing the oven
door(s).
Attach the exhaust deflector to the front of the oven. It
attaches to the oven just below the oven chamber in the
door jam. On a double oven, the exhaust deflector is
mounted below the bottom oven chamber.
1.
Line up the mounting holes on the exhaust deflector
with the screw holes on the front of the oven.
2.
Secure it using the three (3) screws provided.
Reinstall the Oven Door(s)
WARNING
To avoid damage to the door or personal injury from it
falling off its hinges:
Make sure that the notch on the bottom of each hinge
rests on top of the lower lip of each hinge receptacle
before attempting to open the oven door.
Rotate the hinge locks toward the front of the oven
immediately and completely after installation of the
door.
CAUTION
On double ovens: Install the upper door first to prevent
damage to the lower door.
1.
Grasp the oven door on opposite sides and hold it at a
15° angle from the front of the oven. See facing page.
2.
Slide the hinges into the hinge openings, resting the
bottom of the hinge arms on the hinge receptacles.
3.
Continue to hold the door at a 15° angle with one hand
while pushing in on each of the bottom corners of the
door. Push until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
4.
Lower the door to the fully opened position.
5.
Rotate the two hinge locks toward the oven. Slowly and
carefully open and close the door completely to make
sure that it is properly installed.
Verify Proper Operation
WARNING
Read the accompanying use and care manual completely
before using the oven.
1.
Remove any packaging from inside the oven(s).
2.
On some models there is protective plastic coating over
the stainless steel surfaces. Peel them off before use.
3.
Slide the oven racks onto the support racks in the oven
chamber(s) as instructed in the use and care manual.
4.
Turn on the power to the oven at the circuit breaker
or fuse box. Set the clock as instructed in the use and
care manual.
5.
Set the oven to bake mode as instructed in the use and
care manual.
NOTES:
If the oven does not operate properly, follow these
troubleshooting steps:
Verify that power is supplied to the oven.
Check for proper electrical connection.
Repeat the above bake test.
If the appliance still does not work, contact Dacor
Distinctive Service at (877) 337-3226. Do not attempt
to repair the appliance yourself. If you need service, be
sure to have the model and serial numbers available
when you call. See page 3 for location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.