Dell Alienware Area-51 Threadripper Edition R3 Alienware Area-51 Threadripper - Page 59
Removing the drive-bay heat sensor cable, Prerequisites, Procedure
View all Dell Alienware Area-51 Threadripper Edition R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Removing the drive-bay heat sensor cable WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Prerequisites 1 Remove the stability foot. 2 Remove the left and right side-panels. See "Removing the side panels". Procedure 1 Lay the chassis on the right side. Locate the drive-bay heat-sensor connector (SENSOR2) on the system board. For more information on the drive-bay heat-sensor connector, see "system-board components". 59
Removing the drive-bay heat
sensor cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
. After working inside your
computer, follow the instructions in
After working inside your computer
.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance
.
Prerequisites
1
Remove the
stability foot
.
2
Remove the left and right side-panels. See “
Removing the side panels
”.
Procedure
1
Lay the chassis on the right side. Locate the drive-bay heat-sensor connector
(SENSOR2) on the system board. For more information on the drive-bay
heat-sensor connector, see “
system-board components
”.
59