Dell DR6300 DR Series System Command Line Reference Guide - Page 120
This command resets the Integrated Dell Remote Access Controller iDRAC .
View all Dell DR6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
maintenance --remote_access [--enable] Description The command enables the iDRAC access (default: DHCP). Syntax maintenance --remote_access --enable Result Successfully enabled remote access. maintenance --remote_access [--racreset] Description This command resets the Integrated Dell Remote Access Controller (iDRAC) . Syntax maintenance --remote_access --racreset maintenance --remote_access [--static_ip] [--ip ] [--netmask ] [--gateway ] [--device ] Description The command assigns a static IP address for Integrated Dell Remote Access Controller (iDRAC). Syntax maintenance --remote_access [--static_ip] [--ip ] [-- netmask ] [--gateway ] [--device ] --static_ip Assign a static IP address for Integrated Dell Remote Access Controller (iDRAC). --ip Static IP address to use. --netmask Netmask for the assigned static IP address. --gateway Gateway for routing. --device Network device for iDRAC. By default, if you do not specify a device, the iDRAC port will be used. For example, to enable the remote access, you can run a similar command like the one below: maintenance --remote_access --enable --static_ip --ip 10.250.241.167 --netmask 255.255.252.0 --gateway 10.250.240.1 Result Successfully enabled remote access maintenance --remote access [--disable] Description The command disables the iDRAC access (default: DHCP). Syntax maintenance --remote access --disable 120