Dell DR6300 DR Series System Command Line Reference Guide - Page 47
Ethernet Channel Bonding Driver: v3.4.0 October 7, 2008
View all Dell DR6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Description NOTE: When entering the network --troubleshoot command string, the DR Series system checks and displays the current state for all of the --troubleshoot options. To limit the type of network troubleshooting check you want to display, define the command string to a specified check (or checks). For example, using network --troubleshoot -gateway, displays the status of the gateway for a DR Series system (for details, see network --troubleshoot [-gateway]). Syntax network --troubleshoot Result *** Checking link status for each interface bond0 : Link detected: yes eth0 : Link detected: yes eth1 : Link detected: yes eth2 : Link detected: yes eth3 : Link detected: yes lo : Link detected: yes *** Getting local IP addresses bond0 addr:10.25.20.23 Mask:255.255.245.0 *** Getting bond information Ethernet Channel Bonding Driver: v3.4.0 (October 7, 2008) Bonding Mode: transmit load balancing Primary Slave: None Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Link Failure Count: 0 Permanent HW addr: 00:50:56:93:59:7a Slave Interface: eth1 MII Status: up Link Failure Count: 0 Permanent HW addr: 00:50:56:93:59:7b Slave Interface: eth2 MII Status: up Link Failure Count: 0 Permanent HW addr: 00:50:56:93:59:7c Slave Interface: eth3 MII Status: up Link Failure Count: 0 Permanent HW addr: 00:50:56:93:59:7d *** Getting Gateway status Gateway IP address is 10.25.20.1 Route to the gateway is up and uses bond0 interface. Pinging gateway 10.25.20.1 Ping successful. No packet loss. RTT timings min/avg/max/mdev = 0.332/1.612/3.742/1.274 ms 47