Dell DR6300 DR Series System Command Line Reference Guide - Page 92
system --add_storage --enclosure <service tag>
View all Dell DR6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
and 7.1, Backup Exec 2010 and 2012, and Veeam 5.7 and 6.0. For a complete list of the supported DMAs, see the Dell DR Series System Interoperability Guide. Syntax system --marker --disable Result Successfully disabled system marker. system --marker [--enable] Description Enables the marker detection status for all supported backup software on a DR Series system. For example, the DR Series system supports specific versions of data management application (DMA) software like NetBackup version 6.5 and 7.1, Backup Exec 2010 and 2012, and Veeam 5.7 and 6.0. For a complete list of the supported DMAs, see the Dell DR Series System Interoperability Guide. Syntax system --marker --enable Result Successfully enabled system marker. system --add_storage --enclosure Description Adds a data storage expansion shelf (enclosure) to a DR Series system. Each expansion shelf that is added to a DR Series system requires an individual service tag and a license. For details about the maximum allowable expansion shelves and their capacities, see the Dell DR Series System Administrator Guide at dell.com/support/manuals. NOTE: The 300 Gigabyte (GB) drive capacity (2.7 TB) version of the DR Series system does not support the addition of expansion shelf enclosures. For more information about the required licenses, see system --show [--license] [--verbose] and system --license [-validate] [--add]. NOTE: The recommended process for adding an expansion shelf enclosure involves the following tasks: • Use the system --license [--validate] [--add] command to validate and install the license for the expansion shelf enclosure. For specific information, see system --license [--validate] [--add]. • Power off (if needed) the Dell MD1200 storage array, physically connect the expansion shelf enclosure to the base DR Series system, and power on the expansion shelf enclosure. • Use the system --add_storage --enclosure command . NOTE: Each added expansion shelf enclosure must be equal to or greater than each DR Series system internal drive slot capacity (0-11). Because 1 TB drives are the smallest one supported by the expansion shelf enclosure you add, the 600 Gigabyte (GB) DR Series system needs to use 1 TB or larger sized drives in any expansion shelf enclosure added to the base system. NOTE: To verify the current types of storage on a DR Series system, use the DR Series system CLI command: system --show --storage. For more information, see system --show [--storage]. Syntax system --add_storage --enclosure CTKHVW1 92