Dell Force10 E600i E600 TeraScale Installation Guide - Page 10
Power Requirements
View all Dell Force10 E600i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
www.dell.com | support.dell.com Power Requirements The E600i supports either 2500W AC power supplies (PSUs), or DC Power Entry Modules (PEMs).Do not mix and match power supplies. Your system must be powered by only AC or DC power, it cannot use both at the same time. NOTE: Do not use different versions of power supplies. If you are replacing an AC power supply, you must replace all the PSUs in your system with the new versions. Contact Dell Force10 Technical Support if you have any question regarding the version of PSU used in your system. 2500W AC Power Requirements The E600i 2500W AC power supply (CAT# CC-E600i-2500W-AC2) can operate at either 100 VAC or 220 VAC. If the E600i is connected to an 100 VAC power supply, it provides up to 1500W. Parameter Nominal Input Voltage Maximum AC Power Supply Input Maximum System Power Input Specifications 100 - 120 VAC Requires a minimum of 3 Power Supplies Installed 200 - 240 VAC Requires a minimum of 2 Power Supplies Installed 16 A @ 100 VAC per module 12 A @ 200 VAC per module 4.80 KVA @ 100 VAC 4.60 KVA @ 220 VAC DC Power Requirements Each E-Series system requires at least one DC PEM to operate. Two units are recommended for full facility redundancy. Parameter Maximum DC PEM Input Current System Input Voltage Specifications 75 A 2800 W (9600 BTU/hour) -48 to -60 VDC Storage Requirements If you do not install all of your system components, store them in the original packaging in an environment: • constant temperature between -40°F to 158°F (-40°C to 70°C) • non-condensing relative humidity between 5 and 95% • dry, away from direct sunlight, heat, and air conditioning ducts • dust-free 10 | Site Preparation