Dell Force10 S2410-01-10GE-24P SFTOS Command Reference - Page 251

15 GARP Commands This chapter provides a detailed explanation of the General Attribute Registration Protocol (GARP) commands, including GVRP and GMRP commands. The commands are divided into two functional groups: • Show commands display switch settings, statistics, and other information. • Configuration commands configure features and options of the switch. For every configuration command, there is a show command that displays the configuration setting. Note: The GARP and GVRP features were available in SFTOS before version 2.5.1, but the commands were not tested in either 2.5.1 or 2.5.2, so the commands in this chapter are not supported. The sections in this chapter are: • GARP Commands on page 251 • GARP VLAN Registration Protocol (GVRP) Commands on page 254 • GARP Multicast Registration Protocol (GMRP) Commands on page 257 GARP Commands The commands in this sections are: • set garp timer join on page 251 • set garp timer leave on page 252 • set garp timer leaveall on page 253 • show garp on page 253 set garp timer join This command sets the GVRP join time per port and per GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group. This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds). the value 20 centiseconds is 0.2 seconds. Syntax nECu: sduCa,Esu1T0e-1a0o0u oeunECu: sduCa,EsuTeaou GARP Commands | 251