Dell Force10 S2410-01-10GE-24P SFTOS Command Reference - Page 440

www.dell.com | support.dell.com Type-value-External Type 1 or External Type 2 routes Tag-value-Decimal value attached to each external route Subnets-For redistributing routes into OSPF, the scope of redistribution for the specified protocol Distribute-list-The access list used to filter redistributed routes Default-info originate-Indicates whether the default routes received from other source protocols are advertised or not Max Paths-Maximum number of paths that OSPF can report for a given destination show ip ospf abr This command displays the internal OSPF routing table entries to Area Border Routers (ABR). Syntax show ip ospf abr Mode Privileged Exec and User Exec Report Fields Type-The type of the route to the destination. It can be either: • intra - Intra-area route • inter - Inter-area route Router ID-Router ID of the destination Cost-Cost of using this route Area ID-The area ID of the area from which this route is learned Next Hop-Next hop toward the destination Next Hop Intf-The outgoing router interface to use when forwarding traffic to the next hop show ip ospf area This command displays information about the area. The areaid identifies the OSPF area that is being displayed. Syntax show ip ospf area areaid Mode Privileged Exec and User Exec Report Fields AreaID-The area ID of the requested OSPF area Aging Interval-A number representing the aging interval for this area External Routing-A number representing the external routing capabilities for this area Authentication Type-The configured authentication type to use for this area 440 | OSPF Commands