Dell Force10 S2410-01-10GE-24P SFTOS Command Reference - Page 466

www.dell.com | support.dell.com • Configuration commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting. Note: The DVMRP feature was available in SFTOS before version 2.5.1, but the commands were not tested in either 2.5.1 or 2.5.2, so the commands in this section are not supported. This section contains the following commands: • ip dvmrp (global) on page 466 • ip dvmrp (interface) on page 466 • ip dvmrp metric on page 467 • ip dvmrp trapflags on page 467 • show ip dvmrp on page 467 • show ip dvmrp interface on page 468 • show ip dvmrp neighbor on page 468 • show ip dvmrp nexthop on page 469 • show ip dvmrp prune on page 470 • show ip dvmrp route on page 470 ip dvmrp (global) This command sets administrative mode of DVMRP in the router to active. IGMP must be enabled before DVMRP can be enabled. Syntax [no] ip dvmrp The no version of this command sets the administrative mode of DVMRP in the router to inactive. IGMP must be enabled before DVMRP can be enabled. Default disabled Mode Global Config Command History Version 2.5.2 Version 2.5.1 Unsupported: not tested in 2.5.2 Unsupported: not tested in 2.5.1 ip dvmrp (interface) This command sets administrative mode of DVMRP on an interface to active. Syntax [no] ip dvmrp The no version of this command sets administrative mode of DVMRP on an interface to inactive. Default disabled Mode Interface Config 466 | IP Multicast Commands