Dell Force10 S60-44T Installing the S60 System - Page 46

www.dell.com | support.dell.com Battery Replacement and Recycling CAUTION: The lithium battery is not field replaceable. Only authorized personnel should remove and replace the lithium battery. If the battery requires replacement, contact Dell Force10 Technical Support. WARNING: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S60 system and its components. As with all electrical devices, take all the necessary safety precautions to prevent injury when installing this system. To remove the battery, follow these steps: Step Task 1 Remove the small Phillips screws that connect the top to the body. There are three evenly spaced screws across the rear and three evenly spaced screws along each side. 2 Slide the top backwards until its front flange slides free of the faceplate. Lift it off. 3 Insert a small, flat screw driver blade under the battery and in one of the slots of the plastic retainer underneath the battery. 4 Lever the battery up against the coin cell clip (the hold-down lead on top of the battery) far enough to provide room for the battery to be lifted above the edge of its retainer, as shown. Batteries or packaging for batteries are labeled in accordance with European Directive 2006/66/EC concerning batteries and accumulators and waste batteries and accumulators. The Directive determines the framework for the return and recycling of used batteries and accumulators as applicable throughout the European Union. This label is applied to various batteries to indicate that the battery is not to be thrown away, but rather reclaimed upon end of life per this Directive. 46 | S60 Specifications