Dell Force10 S60-44T Installing the S60 System - Page 7
The S60 System, Introduction - 12g stacking modules
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2 The S60 System Introduction The Dell Force10 S60 system is a high-performance, high-capacity, low-cost, stackable, Layer 2 switch/ Layer 3 router that supports 44 built-in 10/100/1000 Base-T ports, four Small Form-Factor Pluggable (SFP) ports, an optional Small Form-Factor Pluggable Plus (SFP+) module, and optional 12G or 24G stacking modules. The front of the S60 (Figure 2-1) contains the Power Supply Units (PSUs), optional module slots, and the grounding connectors. The rear of the S60 (Figure 2-2) contains the 44 ethernet ports, optional module ports, management ports, and displays for alarms and stacking identification. Figure 2-1. The Front of the S60 System Ground Connectors Mounting Bracket Power Connector (AC shown) Fans Mounting Bracket Optional Module (OPT1) Power Supply (PSU0) Figure 2-2. The Rear of the S60 System Power Supply (PSU1) Stack ID Management Ports Ethernet Ports SFP Ports Alarm LEDs Optional Module (OPT0) NOTE: The ethernet ports are labeled 0-43. When cabling these ports, be sure not to interfere with the airflow from the small vent holes above and below the ports. The S60 System | 7