Denon AVR 2805 Owners Manual - Page 50

Preset memory The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand of your device. For some models the remote control unit or the device may not operate properly. In this case, use the learning function (page 53) to store your device's remote control signals in the included remote control unit. 1 Press the power ON/SOURCE button and the OFF button at the same time. • The LEARNED/TX indicator flashes. 1 1 2 Press the mode button of the equipment that is to be entered to a preset memory. 2 • The mode button flashes. 3 3 1 2 3 Referring to the included List of Preset Codes, use the number 4 5 6 buttons to input the preset code (a 4-digit number) for the 7 8 9 manufacturer of the component whose signals you want to store in 0 the memory. 4 When stored correctly, the mode button and the LEARNED/TX indicator will light. 5 To store the codes of another component in the memory, repeat steps 1 to 4. NOTES: • Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the included list of preset codes. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and check it out. • The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE. The preset codes are as follows upon shipment from the factory and after resetting: TV, VCR HITACHI CD, TAPE DENON CDR/MD DENON (CDR) DVD/VDP DENON (DVD) DBS/CABLE ABC (CABLE) DVD preset codes B Model No. 0000 DVD-900 DVD-910 DVD-1000 DVD-1200 DVD-1500 DVD-2200 DVD-2800 DVD-2800II DVD-2900 DVD-3800 DVD-5900 DVD-9000 DVM-1800 DVM-1805 DVM-1815 DVM-2815 DVM-4800 0001 DVD-800 DVD-1600 DVD-2000 DVD-2500 DVD-3000 DVD-3300 50