Denon AVR 2805 Owners Manual - Page 85
Last Function Memory, Initialization Of The Microprocessor
UPC - 081757506076
View all Denon AVR 2805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Recalling preset stations • Recalling preset stations from the remote control unit. 1 Watching the display, press the SHIFT button to select the preset memory block. (Remote control unit) 2 Watching the display, press the CHANNEL + (UP) or - (DOWN) button to select the desired preset channel. 1 (Remote control unit) • Recalling preset stations from the main unit's panel. 2 1 Press the TUNING PRESET button. TUNING PRESET (Main unit) 2 2 FUNCTION Turn the FUNCTION knob and select the desired preset channel. (Main unit) 1 14 LAST FUNCTION MEMORY • This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off. This function eliminates the need to perform complicated resetting when the power is switched on. • The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the main unit's power switch is off and with the power cord disconnected. 15 INITIALIZATION OF THE MICROPROCESSOR When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure. 1 Switch off the unit using the main unit's power operation switch. 2 Hold the following INPUT MODE button and ANALOG button, and turn the main unit's power operation switch on. 3 Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized. 1, 2 2 NOTES: • If step 3 does not work, start over from step 1. • If the microprocessor has been reset, all the settings are reset to the default values (the values set upon shipment from the factory). 85