Denon AVR 2805 Owners Manual - Page 68

11 SURROUND Before playing with the surround function • Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup (see page 32~34) or from the remote control unit, as described below. • Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory. 1 Press the TEST TONE button. (Remote control unit) 2 Test tones are output from the different speakers. Use the channel volume adjust buttons to adjust so that the volume of the test tones is the same for all the speakers. (Remote control unit) 3 After completing the adjustment, press the TEST TONE button again. 2 1, 3 (Remote control unit) • After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below. 1 Select the speaker level you want to adjust. (Remote control unit) 2 The channel switches as shown below each time the button is pressed. 1 FL C FR SR SBR SBL FADER SW SL 2 Adjust the level of the selected speaker. (Remote control unit) When the surround back speaker setting is set to "1spkr" for "Speaker Configuration", this is set to "SB". NOTES: • The adjustment range for the different channels is +12 dB to -12 dB. • The sound from the subwoofer can be cut by lowering the SW (subwoofer) setting one step from -12 dB (setting it to "OFF"). 68