Denon AVR 2808CI Owners Manual - English - Page 53

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Convenient Functions Channel Level You can adjust the channel level either according to the playback sources or to suit your taste, as described below. 1 Press CH SELECT. Channel Volume FL 0.0dB SR 0.0dB C 0.0dB SBR 0.0dB FR 0.0dB SBL 0.0dB SW 0.0dB SL 0.0dB Fader FRONT : REAR 2 Use ui or CH SELECT to select the speaker. The speaker that can be set switches each time one of the buttons is pressed. 3 Use o p to adjust the volume. b "OFF" can be set by pressing o when the subwoofer's volume is set to -12 dB. Fader Function This function lets you adjust (fade) the sound from all the front or rear speakers at once. 1 Press CH SELECT. 2 Press ui or CH SELECT to select "Fader". Quick Select Function With this function, the currently playing input source, input mode, surround mode, room EQ settings and volume can be stored in the memory. 1 Set the input source, input mode, surround mode, room EQ settings and volume to the conditions you want to store. 2 Press and hold the desired QUICK SELECT. Keep pressing the button until the quick select indicator lights. Last Function Memory This stores the settings as they were directly before the standby mode was set. When the power is turned back on, the settings are restored to as they were directly before the standby mode was set. Backup Memory The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected. [Quick Select Defaults] Quick Select 1 Quick Select 2 Quick Select 3 Input Source DVD TV/CBL VCR Volume -40 dB -40 dB -40 dB • To call out the settings, press QUICK SELECT at which the desired settings were stored. • The Quick Select name can be changed (vpage 32). NOTE Input sources stored with the quick select function cannot be selected if they have been deleted at menu "Manual Setup" - "Option Setup" - "Source Delete" (vpage 31). In this case, store them again. Resetting the Microprocessor Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. 1 Turn off the power using . 2 Press while simultaneously pressing and . 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. Personal Memory Plus Function This function sets the settings (input mode, surround mode, etc.) last selected for the individual input sources. When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. 3 Use o p to adjust the volume of the speakers. (o: front, p: rear) The surround parameters, tone control, room EQ settings and the volumes of the different speakers are stored for the individual surround modes. • The fader function does not affect the subwoofer. • The fader can be adjusted until the volume of the speaker adjusted to the lowest value is -12 dB. 50