Denon AVR 2808CI Owners Manual - English - Page 58

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Signal transmission indicator [ AMP] [MODE SELECTOR] [SYSTEM CALL] [POWER ON] [CHANNEL +/-] [NUMBER] [RC SETUP] [8], [9], [6], [7], [1], [3], [2] System Call Function This function lets you register a series of operations at a single button. For example, the amplifier can be turned on, the input source selected, the monitor's power turned on, the source device's power turned on and the play mode set all by pressing a single button. Up to 32 signals each can be registered at [SYSTEM CALL] (1, 2 or 3). Registering 1 Press [MODE SELECTOR] for the device you want to register. 2 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 3 Press [9], [7] and [8], in that order. The signal transmission indicator flashes twice and the system call registration mode is set. 4 Press [SYSTEM CALL] (1, 2 or 3) at which you want to register the signals. 5 Press the buttons you want to register in the same sequence as the operations you want to perform. The signal transmission indicator lights when a button is pressed. Example : Press [POWER ON]. ↓ Press [MODE SELECTOR] - [DVD]. ↓ Press [1]. b The mode can be switched by pressing [MODE SELECTOR]. b Perform the registration procedure for all the buttons you want to register. 6 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed. Calling out 1 Press [AMP], to select "SYSTEM CALL". 2 Press [SYSTEM CALL] (1, 2 or 3) at which the signals were registered. The registered signals are transmitted in the registered sequence. Punch Through Function CD, DVD or VCR mode buttons can be stored at unused TV or SAT/CBL mode buttons. For example, when DVD mode buttons are assigned to the TV mode, the DVD mode operations can be performed while in the TV mode. 1 Press [MODE SELECTOR] for the device you want to punch through (CD, DVD or VCR). 2 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 3 Press [9], [8] and [4], in that order. The signal transmission indicator flashes twice and the punch through setting mode is set. 4 Press the button you want to punch through (1, 2, 6, 7, 8, 9 or 3). 5 Press [MODE SELECTOR] for the device you want to punch through (TV or SAT/CBL). 6 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed. Setting the Time the Backlight Stays Lit 1 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 2 Press [9], [7] and [3], in that order. The signal transmission indicator flashes twice and the backlight on time setting mode is set. 3 Set the light on time. The signal transmission indicator flashes twice. [Settable times] : [1] : 5 sec. [2] : 10 sec. (Default) [3] : 15 sec. [4] : 20 sec. [5] : 25 sec. 55