Denon AVR2307CI Owners Manual - English - Page 66
Setting the Room Equalizer Setup, Setting the Crossover Frequency
UPC - 081757507103
View all Denon AVR2307CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
ENGLISH Advanced Setup - Part 2 Setting the Crossover Frequency Set the frequency (Hz) below which the bass sound of the various speakers is to be output from the subwoofer. For speakers that are set to "Small", frequencies under the crossover frequency are cut before the signal is output, and the low frequency component that was cut is output from the subwoofer or the speakers that are set to "Large". 1 Press D H to select "Crossover Frequency", then press ENTER. 2 Press F G to set. 40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz: Set as desired according to your speakers' bass playback ability. 3 Press ENTER. 1 2 • The crossover frequency mode is valid only when subwoofer is set to "ON", and when one or more speakers are set to "Small", as described in section "Setting the Speaker Configuration" ( page 60). • If "LFE+Main" is set at "Subwoofer Setup", "SW:LFE+Main" ( page 61) is displayed at the top right of the screen. Others Setup Setting the Room Equalizer Setup Set the Room Equalizer setting with "All" or "Assign" for each surround mode. 1 Press D H to select "Room EQ Setup", then press ENTER. 2 Press F G to set, then press ENTER. All: Sets the equalizer for all surround modes. Assign: Sets the equalizer individually for each surround mode ( 28). page 3 When "All" is selected: Press F G to set. OFF: The equalizer is not used. Normal: Adjust the frequency response of all speaker suitable for general surround system. Front: Adjusts the frequency response of the surround speakers to match the characteristics of the front channel speakers. Flat: Adjusts the frequency response of all speakers to the flattest response. This mode is suitable for multi-channel music surround sound sources. Manual: Selects the setting value that was set in the "Setting the Manual Equalizer Setup" ( page 57). Advanced Setup - Part 2 1 2 3 • The equalizer setting of "Normal", "Front" and "Flat" can be selected after performing the Auto Setup. • When the speaker set as "None" with the Auto Setup is changed to on manually, the equalizer of "Normal", "Front" and "Flat" cannot be used. • When headphones are connected, the Room Equalizer cannot be used. 4 Press ENTER. • Set to "80 Hz" when using regular speakers. When using small speakers, we recommend setting to a higher frequency. 63 ENGLISH