Dewalt DW369CSK Instruction Manual - Page 13

DW368/605266 7/2/02 11:50 AM Page 10 English ADJUSTING DEPTH ADJUSTMENT AND BEVEL ADJUSTMENT LEVERS. It may be desirable to adjust the depth adjustment lever or the bevel adjustment lever. (They may loosen in time and hit the shoe before tightening). To tighten either, follow the steps below. DISCONNECT PLUG FROM POWER SUPPLY 1. Using a small screwdriver, pry the lock ring (A) off. 2. Remove the lever and rotate it in the desired direction about 1/8 of a revolution. 3. Reinstall the lock ring with the concave side against the lever to A hold it in place. ADJUSTING DEPTH ADJUSTMENT LEVER - (DW369 ONLY) 1. Loosen the screw securing the lever. 2. Remove lever and rotate it to the desired location, about 1/8 of a revolution. 3. Tighten lever screw. Blades A dull blade will cause slow, inefficient cutting, overload on the saw motor, excessive splintering and increase the possibility of kickback. Change blades when it is no longer easy to push the saw through the cut, when the motor is straining, or when excessive heat is built up in the blade. It is a good practice to keep extra blades on hand so that sharp blades are available for immediate use. Dull blades can be sharpened in most areas; see SAWS-SHARPENING in the yellow pages. Hardened gum on the blade can be removed with kerosene, turpentine, or oven cleaner. Anti-stick coated blades can be used in applications where excessive build-up is encountered, such as pressure treated and green lumber. Accessories Recommended accessories for use with your tool are available at extra cost from your local service center. CAUTION: The use of any non-recommended accessory may be hazardous. DO NOT USE WATER FEED ATTACHMENTS WITH THIS SAW. VISUALLY EXAMINE CARBIDE BLADES BEFORE USE. REPLACE IF DAMAGED. COMBINATION FRAMING - 5/8" Round arbor, 24 teeth All purpose fast rip and cross cuts. PRESSURE TREATED/WET LUMBER - 5/8" Round arbor, 20 teeth Coated - Resistant to gum build-up EXTREME DURABILITY - 5/8" Round arbor, 18 teeth Coated, rock carbide FINISHING - 5/8" Round arbor, 36 teeth More teeth for finer finish cuts. FAST CUT FRAMING - 5/8" Round arbor, 16 teeth Fastest blade for rips and cross cuts If you need any assistance regarding blades or accessories, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 or call 1-800-4-DEWALT (433-9258). Full Warranty DEWALT heavy duty industrial tools are warranted for one year from date of purchase. We will repair, without charge, any defects due to faulty materials or workmanship. For warranty repair information, call 1-800-4-DEWALT. This warranty does not apply to accessories or damage caused where repairs have been made or attempted by others. This warranty gives you specific legal rights and you may have other rights which vary in certain states or provinces. 10